How to Solve Different Water Heater Problems

A large percentage of households owns and uses at least one standard water heater. A majority of these people have also faced problems with these water-heating devices once since the original installation. This is not at all unusual considering the frequency of their use.

The easy way in the case of a malfunction is hiring the experts to handle it. This is, however, neither the fastest nor the cheapest solution for many. Luckily, you can learn how to deal with the most frequent issues and fix them yourself in a jiffy. Here is our guideline.

General concerns

Regardless of the scope of the problem you have, you mustn’t rush it and start mending it by heart. Do a careful and thorough check-up and steer clear of meddling with the inside repairs before turning of the power completely. Although it may seem a bit redundant to mention this, it’s a general warning you should take seriously so you wouldn’t hurt yourself or damage the appliance.

Problems with temperature

If you’re not getting any hot water, the initial step is to check whether the thermostat is properly set. In case your standard settings and your habits haven’t changed, the next step is to do a test with the thermostat. If you set it correctly, wait long enough and the problem persists, you probably need to repair the heating element. This will restore the regular heating function.

If on the other hand the water is scorching hot and decreasing the values at the thermostat doesn’t fix it, the pressure relief valve has to be replaced.

Also Read:  How to Make the House Move Easy and Tension Free

Water discolouration

When you spot the red and orange tint traces in the water that comes out of the heater, there’s only one possible culprit, the development of rust in the tank interior. This basically means that the anode rod has stopped working properly. Since this element serves to prevent corrosion, you need to obtain a new one to have everything in order. With a good timing, the problem will go away with this step.

Now, if you have been waiting for a while to deal with this issue, a more complex manoeuver has to be performed. The heater should be emptied, dried out completely and repainted on the inside. Still, if you think the situation is beyond repair, the replacement is the only option.


The occurrence of leakage is by far the most common problem concerned with water heaters, claims trusted plumber from Monmouth County. If you cannot pinpoint the leaking point with confidence, the first logical move is to fasten all the inside and outside bolts of the water heater. If this doesn’t help, the second step is to test the pressure relief valve and temperature.

Lastly, if even this doesn’t make a difference, conduct a thorough inspection of the heater for the indications of corrosion. If this proves to be the issue, a replacement is due.


If it’s common for the people in your area to use water filters for tap water, the chances are that the sediments get piled up in your heater as well. Soon enough, you will notice some tell-tale signs that this is what’s causing troubles. As the content gets bigger, water heater becomes less effective (lower temperature) the due to restricted capacity. This calls for an extensive, periodical clean-up.

Also Read:  How To Lower Your Heating Costs by Eliminating Drafts

Empty the tank completely and remove the sediments accumulated on the inside walls. Some heating elements may demand total replacement to restore normal operational status. Be sure to act gently so you don’t disturb the surface and make additional damage. If you’re not entirely confident you can carry out this project without anyone’s assistance, make sure to at least consult the professionals.

The various difficulties caused by the water heater malfunction don’t always require a visit from the plumber. Our tips can undoubtedly help you identify and repair the most frequent issues.

Leave a Comment